View Single Post
      11-16-2012, 12:30 PM   #1235
Lieutenant General
shawnsheridan's Avatar

Drives: 2016 650i GC M-Sport
Join Date: Feb 2010
Location: Houston, TX

iTrader: (0)

Garage List
Originally Posted by Rene_CH View Post
Thank you fro asking back!

My car was produced in Sept 2012 (MY13) and it is 47.5. However, I can not code some very simple features like e.g., HUD turn signals (even if I set the right values) and someone mentioned, that the reason for that could be these six missing files which where included in v47.1 and are missing for some reasons in 47.5.

I do not get any error messages while connecting with esys 3.18.4 to the car, and other features like automatic high beam control work very fine.

Thank you!

If you need any CAFD file, you will get a [CO012] error message, and will not be able to code the module at all, so that is not the problem here.

I am not sure what is up with your HUD Turnsignals. After coding it, did you enable the checkbox in the iDrive HUD Options too?

2016 650i GC M-Sport w/ 20" 373M Wheels; Alpine White; Individual Opal White Full Merino Leather; Gray Poplar Wood Trim
Anthracite Alcantara Headliner; Ceramic Controls; Executive Package w/ B&O Sound System; Integral Active Steering, etc.