View Single Post
      12-04-2012, 03:25 AM   #41
ex o
 
ex o's Avatar
 
Drives: ✖✖
Join Date: Nov 2012
Location: ✖✖✖

Posts: 158
iTrader: (0)

Here is my solution to the front plate on my M-Sport bumper. Cost was about $3.

I prefer the license plate to contour the M-Sport bumper with the same angle and curvature.

No holes are drilled into the front of the bumper. However, there are two small holes that are drilled into the underside of the grille to accomodate a pair of L-Brackets. The license plate is then mounted to the L-Brackets. If the plate and L-Brackets are removed, the holes are not visible unless you get down on the ground and look up.

Last edited by ex o; 12-19-2012 at 09:07 PM.
ex o is offline  
0
Reply With Quote