[jtalweezy]

I managed to replace this with just removing the ECU harness and holding tray. (I needed the extra room for my hand, and it helped to properly route the line) If you look at the front of the engine, you can see past the (fiber board) engine cover to the cylinder head bung. Its going to be under the coolant return line for the low-temp system. (intake charge coolant lines) You can us a long, but slender pick tool to pull up on the clip that holds the plastic fitting to the cylinder head bung. Then you just need to get your hands back there to pull off the hose fitting. It took a little finagling but eventually I got it off.