Quote:
Originally Posted by atzebmw
On your pic it is Nr. 9.
For coding you can VO code "2VB" in FEM, ICM, HU_NBT, Kombi and DSC.
Or here the manually codings:
FEM
RC_RDC_ENABLE = aktiv
ICMQL
IcmKod_B_S2VBA = verbaut
DSC
C_Funktion_RDCi_l = nicht_aktiv
C_Funktion_RPA_e = nicht_aktiv
C_RPA_Extra = nicht_aktiv
HU_NBT
RDC = aktiv
RDC_DRUCK_TEMP = aktiv
RDC_FORTSCHRITTSANZEIGE = nicht_aktiv
REIFENUEBERWACHUNG_RDC_RPA = rdc
RPA = nicht_aktiv
KOMBI
ST_TYR_RDC_ALIVE = aktiv
ST_TYR_RDC_TIMEOUT = aktiv
KOMBI DSC_MIT_RPA = ohne_RPA
|
Hi Everyone I’m desperate to get rdc tpms to work, I’ve added the module and sensors in the wheels and coded as above using BimmerCode apart from FEM as I can’t see it in my F06 GC I realize this not the same model forum but the same topic. It’s a Europe spec car my 14 with rpa all I get is rdc failure message I wired the model as per TIS k_can to reverse camer video module. Parts used are are
Module 36106881474
Sensors are 36106856227
What am I missing?? Please help
Side note I reversed the k_can wires and got pressure reading then rdc failure showed up rechecked all wiring was correct so I switched them back.