Quote:
Originally Posted by __mkw
You are right.
Is based on displayed SWFL is it possible to establish what version of psdzdata was used to flash DME?
In my folder psdzdata I can't find swfl_00002157.xxx.029_100_001
I need to flash FEM or DME because I get this error after engine replace:
1F2108 - DME, incorrect data record: Variant monitoring
Fault description:
The diagnosis monitors the software variants between CAS and DME. Fault monitoring conditions: The fault is detected whenever the software variants fail to match one another.
Action in service:
Continue troubleshooting at following control unit:
-CAS.
-Reprogram and encode the DME.
|
It is not possible to know from SWFL what I-Level ECU is at.
Just flash with latest PSdZData Full though.