Quote:
Originally Posted by kon
This might sound stupid, but how do you unplug the enet cable when you're done coding? It's super easy to plug in, but I have to use considerable amount of force to unplug it to a point I'm afraid I might break something
Is there a easy/easier way to do this?
|
I assume you're talking about the OBD-II plug into the car, right?
There is just a small clip on the connector that holds it in place because it could fall out otherwise.
Just grab it and pull it down, rocking it a bit.
I've coded a dozen cars and I've never run into a sticky or hard to remove connector. It's pretty well made.