View Single Post
      06-06-2012, 12:43 PM   #1
1.fresh.f30.335
Second Lieutenant
United_States
91
Rep
286
Posts

Drives: 2014 535xdrive M-Sport
Join Date: Apr 2012
Location: NH-CT

iTrader: (0)

F30 328i 335i Front Kidney Grill / Grille removal and replacement DIY

BIMMERPOST
     Featured on BIMMERPOST.com
Hey guys,

This is a quick guide to removing and replacing your kidney grills.

Estimated Time: 15-20 minutes

Tools Necessary:
T20 Torx
T30 Torx
small flat head or pick tool

Steps:

1. Locate the rubber hood seal at the front of the engine bay.

Name:  f30grille1.jpg
Views: 222685
Size:  287.2 KB

Name:  f30grille2.jpg
Views: 169416
Size:  228.9 KB


2. Remove the seal, starting at a side will make it easier.

Name:  f30grille3.jpg
Views: 169154
Size:  221.9 KB


3. There are going to be 8 screws (6) T30 torx and (2) T20 torx which need to be removed. A T20 torx screw is located over each headlight

Name:  f30grille4.jpg
Views: 183960
Size:  231.9 KB

Name:  f30grille5.jpg
Views: 194832
Size:  248.6 KB

Name:  f30grille6.jpg
Views: 163347
Size:  185.9 KB


4. Now that all 8 screws are removed, the bumper cover should slide forward. Be careful and make sure to pull straight forward rather than up as there are 4 metal clips which hold the bumper in place which would break.

Name:  f30grille7.jpg
Views: 161984
Size:  193.3 KB

Name:  f30grille8.jpg
Views: 163601
Size:  264.1 KB


5. The bumper cover is flexible to a reasonable extent, allowing for a hand or tool too fit behind the grills. Moving away from the center of the bumper allows for more flex, anyone with big hands would probably find it easiest to start on the outside and work inward.

Name:  f30grille9.jpg
Views: 162993
Size:  167.1 KB

Name:  f30grille10.jpg
Views: 161388
Size:  222.8 KB


6. Now using the flat head or pick tool press the release tabs on the grill while gently pulling on the grill from the outside, there are 3 clips on both the top and bottom of the grill as well as 1 clip on each side.

Name:  f30grille11.jpg
Views: 188137
Size:  253.4 KB

Name:  f30grille12.jpg
Views: 164719
Size:  232.7 KB

Name:  f30grille13.jpg
Views: 163221
Size:  153.2 KB

Name:  f30grille14.jpg
Views: 161811
Size:  177.5 KB

Note: the bottom clips are going to require using your hand rather than the screw-driver because they face the ground.

Name:  f30grille15.jpg
Views: 159198
Size:  197.3 KB


7. Once the first grill is free of the bumper you can easily access the other grill... Don't be impatient and pop a new grill in before having both sides removed, it makes more work for yourself.

Name:  f30grille16.jpg
Views: 185664
Size:  199.0 KB

Name:  f30grille17.jpg
Views: 190080
Size:  308.8 KB


8. Now just gently push the new grills into place, run your hand around the gloss black trim piece to ensure all the clips are secured

*use a microfiber cloth if you don't want fingerprints*

Name:  f30grille18.jpg
Views: 178026
Size:  226.1 KB


9. After the new grills are in place, line the metal clips up with the bumper cover, and then slide it back into place.

Name:  f30grille19.jpg
Views: 161662
Size:  215.6 KB

Name:  f30grille20.jpg
Views: 159257
Size:  175.9 KB

Name:  f30grille21.jpg
Views: 158621
Size:  255.3 KB



10. Once in place replace all 8 screws and prior to tightening them ensure that the bumper cover is even, I did this by comparing two of the outermost points.

Name:  f30grille22.jpg
Views: 158318
Size:  209.5 KB

Name:  f30grille23.jpg
Views: 157448
Size:  246.5 KB


I also repeated this procedure on the rubber seal using the outermost T30 screws as reference points, its not necessary but always helps to keep the car looking it's best.

Name:  f30grille24.jpg
Views: 157643
Size:  185.6 KB

Name:  f30grille25.jpg
Views: 157134
Size:  208.6 KB


I hope this helps answer any questions and Good-luck!
__________________
'12 335i Sport Apline White w/black... Totaled

'14 535i xdrive M-Sport Carbon Black w/Mocha Nappa
Appreciate 19
SD610.00
Kabrich354.00
IK6SPEED4478.50
AndrewC198910902.00
Ace5556.00