View Single Post
      03-23-2013, 11:44 AM   #4
Jadar
Dejan
Jadar's Avatar
Serbia
1751
Rep
4,197
Posts

Drives: 2018 Audi S3
Join Date: Dec 2010
Location: Michigan Ave.

iTrader: (6)

Garage List
Quote:
Originally Posted by shivaswrath View Post
So how are you going to spot weld on the underside?

Wouldn't having a Meineke guy with tubing make a straight through tube design be cheaper? that's essentially what's being done...no?
In chamber 3 yes that would be the way to go, just cut and replace with a tube and weld it back.

The difficult part would be re fabricating the section in chamber 1. It's not round, it's very much oval. Not saying its not possible, but I doubt it be cheaper then just welding each hole.

The underside plan is to open the muffler even further with my angle grinder so I have access to the underside.

I'm not saying this is going to successful but if I close off the perforated tube there will be a change in the exhaust note. I'm not even sure if it will be a good sound, it may be the most annoying thing we ever hear....but we'll all find out soon
__________________
FBO-PS1 and stuff
Appreciate 0