Quote:
Originally Posted by Rene_CH
Thank you fro asking back!
My car was produced in Sept 2012 (MY13) and it is 47.5. However, I can not code some very simple features like e.g., HUD turn signals (even if I set the right values) and someone mentioned, that the reason for that could be these six missing files which where included in v47.1 and are missing for some reasons in 47.5.
I do not get any error messages while connecting with esys 3.18.4 to the car, and other features like automatic high beam control work very fine.
Thank you!
René
|
If you need any CAFD file, you will get a [CO012] error message, and will not be able to code the module at all, so that is not the problem here.
I am not sure what is up with your HUD Turnsignals. After coding it, did you enable the checkbox in the iDrive HUD Options too?