[re4ryu]

Hi,

I have rear PDC only installed on my car, so no buttons to deactivate it. Car is auto transmission.

I was wondering if it was possible to code the PDC so that it immediately disengages when put into drive? At the moment, it only disengages when the car is moved forward slightly.

When trying to get out of a tight space, or when you aren't given way out of a space, the PDC's constant beeping is very annoying, and i have to put the car into park to turn it off...

Thanks!

[pikcachu]

Originally Posted by re4ryu

Hi,

I have rear PDC only installed on my car, so no buttons to deactivate it. Car is auto transmission.

I was wondering if it was possible to code the PDC so that it immediately disengages when put into drive? At the moment, it only disengages when the car is moved forward slightly.

When trying to get out of a tight space, or when you aren't given way out of a space, the PDC's constant beeping is very annoying, and i have to put the car into park to turn it off...

Thanks!

You could code it to disable at 1 meter instead of 15

PDC distance limit REM 3203 D_SCHWELLE_1

[re4ryu]

Originally Posted by pikcachu

You could code it to disable at 1 meter instead of 15

PDC distance limit REM 3203 D_SCHWELLE_1

Thank you very much! I will get this coded tomorrow Hopefully should make the PDC a bit more bearable!

[pikcachu]

Originally Posted by re4ryu

Thank you very much! I will get this coded tomorrow Hopefully should make the PDC a bit more bearable!

cool... you can also change the disable speed too...
Let us know how it goes

[re4ryu]

Originally Posted by pikcachu

cool... you can also change the disable speed too...
Let us know how it goes

Hi again!

I had a look at the D_SCHWELLE_1 parameter, but i'm a bit confused with which option to choose.

At the moment, the option is set to wert_01 (hex is werte=01), and the other options are wert_02 (hex is werte=24) and wert_03 (hex is werte=0). Similar parameters are shown in the V_SCHWELLE_1 option, which i assume is to do with the speed.

How does this work?

[pikcachu]

Originally Posted by re4ryu

Hi again!

I had a look at the D_SCHWELLE_1 parameter, but i'm a bit confused with which option to choose.

At the moment, the option is set to wert_01 (hex is werte=01), and the other options are wert_02 (hex is werte=24) and wert_03 (hex is werte=0). Similar parameters are shown in the V_SCHWELLE_1 option, which i assume is to do with the speed.

How does this work?

just change the werte value, save and then code FDL