[Love The Drive]

Hello All,

I need some help in regards to the electronic shifter in the F30s. Hoping the forum can help me out.

So I got my hands on a stock F30 shifter (picture below) and I would like to power it on and check its functionality. Only problem is, I don't have a car to plug it into.

Does anyone know what each of the 10 pins are? Which pin is for power, how much power it operates on? etc. If I have this info, I may be able to use a DC power supply to power it on and check if it works. Could also hook up an oscilloscope and check on the output readings. But I need to know what each pin is for, otherwise I really can't do much.

Any and all info would be appreciated. Thanks!

[Love The Drive]

Bump! I posted in the coding section assuming I could get some help here.. Anyone? Even recommendations on where I could find out the info would be helpful.

[Love The Drive]

Anyone?

[Love The Drive]

BUMP.

[Rwillis92]

Look up the wiring diagram for pin out

[Love The Drive]

Originally Posted by Rwillis92

Look up the wiring diagram for pin out

Thanks for the reply. I have been trying to find what you mentioned, but had no luck.

Okay so I found some useful information, check out post post 124 on the link.

http://www.bimmerfest.com/forums/sho....php?p=8972418

Still need more info on power supply voltage and output signals though.

[Love The Drive]

Bump.

[lawkmlaw]

Originally Posted by Love The Drive

Thanks for the reply. I have been trying to find what you mentioned, but had no luck.

Okay so I found some useful information, check out post post 124 on the link.

http://www.bimmerfest.com/forums/sho....php?p=8972418

Still need more info on power supply voltage and output signals though.

This is Fantastic

fav link:
SEO

[wolf041]

Hi,
the pinout of the selector is

1 E * Switch signal * Drivelogic button with twin-clutch gearbox
2 -- Not used
3 E/A * PT-CAN bus signal * PT-CAN bus connection
4 E/A * PT-CAN bus signal * PT-CAN bus connection
5 E/A * PT-CAN bus signal * PT-CAN2 bus connection
6 E/A * PT-CAN bus signal * PT-CAN2 bus connection
7 E * Wake-up signal, terminal 15 * Connector, terminal 15 wake-up signal
8 M * Ground * Ground point
9 -- Not used
10 E * Power supply, terminal 30B * Fuse F54

[Love The Drive]

Thanks for the help so far guys.

If anyone has more information they can post about this, it would be greatly appreciated.

Thanks,
Nick