[Rick4345]

When you change the heat and cold checks for the tail lights, do you also have to change the setting that shows they are LED. I thought I saw that this could cause a check engine light.

I already have Weisslicht bulbs in my front turn signals. I haven't noticed any flickering per say. Maybe when I put in the tail lights it will happen. I'm going to use Weisslicht in the rear also.

I have a 2012 F30 with Xenon lighting if that helps.

Thanks!!

[efunnra]

Last night I just coded the Warm and Cold checks out as well as changing the LED option to Aktiv. No CEL here.

[ktula]

Originally Posted by Rick4345

When you change the heat and cold checks for the tail lights, do you also have to change the setting that shows they are LED. I thought I saw that this could cause a check engine light.

The CEL only happened to me once when i did the same change. When i did it again, i did not get the CEL so i am assuming it was a fluke.

[RSnic]

I have Bimmian Weisslicht LEDs for my rear turn signals (Amber) and back up lights. For each of the four bulbs I changed out, I coded out (changed to not active) warm and cold checks, as well as changing LED to active.

Having said that, I installed the bulbs, but didn't get around to code them for about 2 weeks; during that time, I would get a very short flash at start up and then every 3-4 minutes, which is caused by car checking bulb. Regardless, I never got an error because these bulbs have the necessary resistor built in.

[lance666]

What do i need to code for reverse led? When i start car, the reverse light flickers. I coded the rest of led

[QuikSilver_]

Originally Posted by lance666

What do i need to code for reverse led? When i start car, the reverse light flickers. I coded the rest of led

For reverse lights...

Originally Posted by nickhelou

Reverse Lights:
REM / 3061 / RFS_L_KALTUEBERWACHUNG from aktiv to nicht_aktiv
REM / 3061 / RFS_L_WARMUERBERWACHUNG from aktiv to nicht_aktiv
REM / 3061 / RFS_L_IS_LED from nicht_aktiv to aktiv
REM / 3061 / RFS_R_KALTUEBERWACHUNG from aktiv to nicht_aktiv
REM / 3061 / RFS_R_WARMUERBERWACHUNG from aktiv to nicht_aktiv
REM / 3061 / RFS_R_IS_LED from nicht_aktiv to aktiv

[RoundelM3]

Originally Posted by gpjustinn

For reverse lights...

I did this and I have not had any problems. Strange that they separate warm and cold bulb checks like that (why would you want one without the other?).

[lance666]

Originally Posted by gpjustinn

For reverse lights...

Thank u !