02-09-2016, 12:54 AM | #1 |
Captain
137
Rep 647
Posts |
JB4 Map Change Instructions
I'm almost positive I installed this correctly, but not sure why I cannot change maps.
First off, I have an EWG car. The JB4 is the original board which works with PWG and EWG cars. So to installation, I left the boost solenoid and purple/black harnesses tucked and unplugged. Plugged in the other two harnesses where they belong (rainbow and brown I believe). Tapped the green and brown wires into the CANbus wires correctly (quadruple checked this step). Tune is working but can't change maps. |
02-09-2016, 12:38 PM | #2 |
BimmerPost Supporting Vendor
24193
Rep 190,805
Posts |
Are you using Posi-tap or OBd cables?
Make sure you have the correct firmware for either one
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
02-09-2016, 01:42 PM | #3 | |
Captain
137
Rep 647
Posts |
Quote:
I guess that's my problem. I don't have a data cable so I'm not sure which firmware I'm on. So I assume I'm going to have to purchase a data cable and update it? The previous owner changed maps without any issues just by using volume up and down buttons. |
|
Appreciate
0
|
02-09-2016, 01:53 PM | #4 | |
BimmerPost Supporting Vendor
24193
Rep 190,805
Posts |
Quote:
Maybe you did not install the JB4 correctly
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|