[Gooleung]

Hi guys,

Here is my dyno result but i am not sure if the numbers are correct since the operator pulled all the runs on 5th gear instead of 6th also the ratio that he put is 4.1?? I am not sure what that mean but anyways..here is my question. Would it possible to recalculate the numbers so that it would reflect the real numbers based on the result that i have?? Can any dyno expert help me with this?

By the way my car has a jb4 and a high flow cat installed and the max pull that i got is 248hp and 352 Nm.

Thanks!
Matthew

[mperformanceworks]

stage 1 or map 5 on stage 2?

[Gooleung]

Sorry. Stage 2 with map 1 and 5. The green line is map1, purple and blue is on map5.

[mperformanceworks]

Originally Posted by Gooleung

Sorry. Stage 2 with map 1 and 5. The green line is map1, purple and blue is on map5.

You are not supposed to use map 1 on a 320i. Be careful.

[DennisZhang]

Originally Posted by Gooleung

Sorry. Stage 2 with map 1 and 5. The green line is map1, purple and blue is on map5.

on Map5, horsepower is about right but how come you only max at 310Nm...

I actually do NOT want too much torque considering protecting the transmission. High HP with relatively low torque would be very ideal

[timboslice]

What gas are you running?

Seriously though, if the flywheel numbers are accurate estimates then that's still 70hp over stock! Can't expect too much more no?