02-09-2017, 10:15 AM | #1 |
Private
2
Rep 54
Posts |
Spacers F32
Just fitted some 10mm H&R hubcentric spacers to the front and after a quick test drive i have noticed a small juddering through the steering wheel at around 40 mph...i have had ACS springs fitted recently with the geometry done straight after.... since then i have fitted the spacers....do i need another geometry set up etc...
|
02-09-2017, 11:09 AM | #3 |
Colonel
505
Rep 2,152
Posts |
shouldnt need a realignment shouldnt of needed one after lowering on ACS as id be shocked if it was out!
sounds like you fitted the spacers wrong somehow
__________________
Current: BMW M4 F83 - Mods : Pedal Covers, LCI Stereo facia Retrofit and Carbon Rear corner covers
Old: F32 435d M Sport - Mods : HR Sport Springs, 20" Veemann V-FS23 in Gun Metal, M Performance Body Kit, Pedal Covers, Eurspec CF Mirror Caps, More-BHP remap 364 BHP 741 NM, M4 Under Chassis Brace, 15mm Rear ARB, 8.8" Screen Retrofit and LCI Stereo facia Retrofit |
Appreciate
0
|
02-09-2017, 11:49 AM | #5 |
Private
2
Rep 54
Posts |
checked all nuts....tight there no probs....
when you say check to see if the spacers are fitted correctly..... i fitted them on the hub so they are flush and then fitted the alloy on with the extended wheels nuts !!!!the hubcentric spacers were a tight fit but went on ok it seemed.... |
Appreciate
0
|
02-09-2017, 12:01 PM | #6 |
Banned
10994
Rep 32,881
Posts |
Have they gone on completely flush? Some spacer require you to remove the little plastic hub nut caps so they go on fully.
Also did you thoroughly clean the face of the brake disc hat and the mounting surface of the wheels? |
Appreciate
0
|
02-09-2017, 12:08 PM | #7 |
Private
2
Rep 54
Posts |
hub plastic caps are still on....will take the alloys off re clean re seat and see if that sorts it out tomorrow.... had 3 mm spacers on before with no issues... gone up to 10mm and now have an issue .....cheers
|
Appreciate
0
|
02-09-2017, 01:42 PM | #8 |
Private First Class
97
Rep 155
Posts |
I thought the smallest hub centric spacers you could fit were 12mm because the original hub is 10mm to start with.
Think you will have to take the plastic cap off the hub for the spacer to fit completely square to the original brake disk hub |
Appreciate
0
|
02-10-2017, 02:55 AM | #9 |
Private First Class
50
Rep 175
Posts |
That's on the rear hub, 10mm is fine for the front on the F3x series
__________________
Current - BMW F32 M Sport
Previous - BMW F10 M Sport |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|