03-20-2014, 09:11 PM | #1 |
Private
5
Rep 56
Posts |
BMS intake installation?
Hey guys was wondering if anyone has installed there bms intake? Is it hard to do ? Any instructional videos out there ? Thanks
|
03-20-2014, 10:00 PM | #4 |
BimmerPost Supporting Vendor
24174
Rep 190,750
Posts |
it takes 10 minutes a mechanic would probably charge you for 30 mins. thats about 40-50$
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
03-20-2014, 10:04 PM | #5 |
Banned
28
Rep 386
Posts |
|
Appreciate
0
|
03-21-2014, 10:59 AM | #7 |
Lieutenant
36
Rep 465
Posts |
http://burgertuning.com/F30_335_F32_...ke_filter.html
Click the yellow install guide. It's pretty descriptive.
__________________
13 335i Msport
89 E30 325is 5spd |
Appreciate
0
|
03-21-2014, 02:04 PM | #8 | |
Private First Class
8
Rep 104
Posts |
Quote:
Oh and use vice grips to pinch the air recirculation tube out, unless you got a beast mode grip! lol Sound is very subtle, I can really only hear it when I'm in Sport mode.
__________________
Current: G05 2019 x5 xDrive40i M-Sport | Traded: F30 2013 335i Xdrive M-Sport | E92 2011 M3 | 2007 Subaru WRX STi | Sold: 2002 Subaru WRX
|
|
Appreciate
0
|
03-21-2014, 02:20 PM | #9 | ||
Major
426
Rep 1,107
Posts |
Quote:
|
||
Appreciate
0
|
03-21-2014, 02:54 PM | #10 |
BimmerPost Supporting Vendor
4912
Rep 115,980
Posts |
Its a pretty easy install. Definitely a DIY. We've sold a bunch and not one customer has complained about a difficult install.
Mike |
Appreciate
0
|
03-21-2014, 04:19 PM | #12 |
Second Lieutenant
76
Rep 227
Posts |
|
Appreciate
0
|
03-24-2014, 10:50 PM | #15 |
Private
5
Rep 56
Posts |
you guys were right it took about 10 min tops. Realllllyyy sounded good in the garage with the hood open though ha. But yea nothing crazy. Light to light it sounds ok but pretty much can only be heard when you rev 4000 rpm or higher . For some crazy reason idk maybe its just mental i felt that i was reaching higher speeds a little easier/faster. I usually don't go fast but afterwards I caught myself going from 80 to looking down and realizing I'm at 110-120. Anyways I'm just prepping the car for when Dinan releases there tune in may/june.
|
Appreciate
0
|
03-26-2014, 04:45 PM | #16 |
Second Lieutenant
16
Rep 255
Posts |
I installed mine a little while back and it ran pretty well for a while (no CEL either) but a couple weeks down the road I started to experience rough idle (still no CEL) during cold starts. It gets pretty rough. The first time it happened I was driving off and the gas cut in and out with the roughness. It only takes a few seconds to get past it and then it doesn't happen again until another cold start. A little annoying but nothing to be too concerned about...I hope..!
Overall I really like it, though! The sound improvement is amazing. Not so sure about speed improvements or throttle response. It may even be a little slower lol I'm wondering if the Texan heat has something to do with that, though. The DYNO's were performed at boost levels greater than stock (I think) and with an open hood, which I believe may be a factor to investigate. But then again I don't know what I'm talking about! |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|