03-09-2014, 01:53 AM | #1 |
Registered
0
Rep 4
Posts |
FA read error
Hi, this is my first time coding and after connecting to the car successfully using the F020 (non direct) connection, I can't move on to the next step of reading from FA and have been getting the error messages: https://www.dropbox.com/s/8q17bbs69w4gh96/Error.docx
I also can't seem to read the i-steps from the VCM window. I'm using E-SYS v3.23.4 and 52.1 PSdZdata. Has anyone seem similar errors and managed to resolve them? |
03-09-2014, 03:45 AM | #4 |
Brigadier General
5685
Rep 3,225
Posts |
Yes, takes around a minute or so the first time you connect each time.
All I can suggest is to let the car have a sleep and try again. I know it's redundant but, just in case, you are following the instructions correctly? Connect, read VO and then the FA comes up in the VO section? |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|