[smilo]

Hi everybody,

As the new Kombi2 came only since few months on the F20Lci, I don't find anything to answer my question.
I have installed this cluster last week on the F20 preLCI, all coded without any issue. The kombi works perfectly but the problem is that when the car is closed and leaved alone, 2 or 3 seconds after all lights switch off inside, the car wakes up again and we see the GWS and Start/Stop lights come on again. We also can hear the idrive booting..
After few minutes, the car sleep again, and again 2 or 3 secondes we can see GWS and Start/Stop lights come on..

I flashed all the car with 3.62.4, changed the FA date for Kombi2 coding and other ECU, checked some FDL parameter by comparing with CAFD of old Kombi.. without success.

Someone could have an idea please ?

Attached some picture of this kombi2 running

[smilo]

No one has done this retrofit before ?! or no one had this issue ?
Strange ! it's a really good kombi version -

Please if someone has any idea, I think this problem could happen with any other ECU..

[smilo]

This is the video of the car few minutes after it was closed.
The video shows the moment when the car goes on standby mode - then we can see GWS and Start&Stop lights come on again:

[MHL]

I dont know buddy, but i would ask it in the F20 section if I were you.

[smilo]

Originally Posted by MHL

I dont know buddy, but i would ask it in the F20 section if I were you.

I already asked to move the thread - waiting for their reply

[randomx]

keen to hear about this issue. i want to do this mod too.

where did you get the kombi2?

[smilo]

Originally Posted by randomx

keen to hear about this issue. i want to do this mod too.

where did you get the kombi2?

From BMW - local dealer

[RobbPT]

Hi!
Did you find the solution for the problem?