10-21-2015, 05:58 PM | #1 |
New Member
0
Rep 5
Posts |
ECO Pro speed limit coding?
So I've gotten setup to code my car and I've been successful with everything so far. I was poking around in the menus and showing someone the new ride and I got into the ECO Pro settings and I noticed something odd.
The speed limit range in the settings is now 90-130mph. I've tested ECO Pro cruising down the freeway at 80-90 mph and the car calculates I'm getting nearly 37-39mpg... The only coding I've done with ECO Pro settings is turning it off by default. I'm not sure when it happened, I've been adding new things as I find them or need them (LED's arriving in the mail), and I hadn't been using ECO Pro until I stumbled on this change. I know when I got the car the range was the normal 35-75 mph when I went through everything in the settings. Anyone know what settings changes this range? |
10-22-2015, 10:13 AM | #5 |
New Member
0
Rep 5
Posts |
It is in mph, ECO Pro is active at 90 mph on the freeway (text is still blue on the KOMBI). If I floor it, or slip the transmission into sport/manual mode, the text becomes grayed out as you would expect in those circumstances.
When I set the limit to 90, and then go above 90, the text will then become grayed out once I go over 90 mph. EDIT: I should also note that the "potential gauge" will max out now at about 50% when I set the limit to 90, and drops even lower when I set the limit higher. Last edited by edifus; 10-22-2015 at 10:34 AM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|