06-20-2023, 01:11 PM | #1 |
New Member
9
Rep 16
Posts |
Nightmare after recall
Evening all,
Collected my car from Dick Lovett today and the EGR software update had wiped all of the coding I've done to the car. Fortunately, I've been able to reset a lot of it but the big issue I've had is trying to get my 8.8 retrofit screen to work and enabling my auto dipped beam button on the indicator stalk (not a retrofit!) On top of that, when I put the car in to a different driving mode it no longer comes up on my idrive.... The car is a 2017 LCI 320d running on HU_NBT_EVO. I've managed to code the touch screen back in again, but I cannot get the map to go full screen for the life of me. It's stuck in 6.6inch! I used a guide on here a few years ago that had comprehensive details on how to fully code the 8.8 screen in on HU_NBT_EVO but I cannot find it, and believe me I've looked!! I've three asks please... Does anyone have the full coding guide for the touch 8.8 idrive screen for HU_NBT_EVO and does anyone know how to reactivate my high beam assist button please? Some assistance enabling the driving modes on the idrive would be amazing too!! Thank you! |
06-20-2023, 01:31 PM | #2 |
Lieutenant
288
Rep 540
Posts |
I've just been coding a touch screen onto an Evo unit myself. I'm not sure if all 3 parameters are needed but I set these and it works though I see you said you've done this already:
CID_TOUCH_SL - aktiv CID_TOUCH - aktiv CID_HMI_TOUCH - aktiv For 8.8" screen you'll want to check: CID_DISPLAY_RES - 1280_480 CID_DISPLAY_SIZE - 8_8 DISPLAY_SIZE_RESOLUTION - 8.8_1280x480 DISPLAY_VARIANTE - breites_display For driver modes, firstly check settings in Evo: Settings > Driving Mode > Driving Mode Info Last edited by Zheez; 06-20-2023 at 01:36 PM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|