Quote:
Originally Posted by aloo6
Ista is the software that the op's drawing came from.
The wires you are missing are the manual beam throw which make sense if you don't have that in the us.
The levellers are drivers side and attach to the suspension post and attach to the control arms. They measure the angle of the car to relay it to the headlight to avoid blinding other folk on the road
Edit/ go into real oem then select the front/rear suspension and that will show you drawings.
|
Hmmm if you have access to that it would certainly be helpful. If you can post the wiring for US spec halogen I am almost ready for my install. Just found and ordered the last module I need for the headlight and now just waiting on wiring confirmation to begin.
Also if anyone has part numbers for screws that hold the modules on (no one seems to know which ones) that would be helpful as well.
I will look into the leveling sensors, but didn't realize it was going to be another issue. I am fine without them as long as the lights are still adaptive.
(edit: I looked at real OEM and it looks like the front suspension sensor set up is relatively cheap <$100 for all parts) Now I just need to figure out wiring which hopefully you can help me with