Quote:
Originally Posted by BunkerJ
So, as someone who has been using the agent for about six months, here is my setup with no issues:
I have mine tucked away underneath the steering wheel (So part #7 of IK6SPEED's photo). ENET cable is tucked away in there as well and while I haven't done it yet, you could unclip the OBDII connector so it can also be tucked away and out of sight. I've just gotten used to the plug at this point. Then I'm taking advantage of the 12v socket underneath the glovebox (it's near the left side, underneath.) with a dual-USB adapter. Then I have the cable wired through the trim, under the A/C controls, and then to the Pi. I then have the second USB port ran a similar route but it comes out just after the A/C controls in order to plug into my cup-holder-mounted tablet, which I use for BM3.
No issues with this setup yet! (Except for the time I left my tablet out and the sun melted the glue on the magnet lol)
|
Part 7 and 8 are screws and clips, fwiw.
Part 5 is below steering wheel over Drivers Footwell.