Quote:
Originally Posted by ehssan_alkhiyami
Usually front and rear PMA sensors are on same height in F3X , measure the front ones from the ground to the center of the PMA sensor , you should get the approximate figures of rear ones . if the rear markings on the bumper are too high comparing to front ones then you will have problem .
also very important is the sensor angle , if has to be facing straight ( not up and not down ) . 100% flat , must be 0 degree angle when it is installed on the bumper .
since you have M3 LCI ,, do you already have PMA from factory or also retrofitting now ?
edit : looking closely at your pic , the X marking is too high .
|
Yes I already have PDC & PMA but I'm adding the two extra rear-side sensors for the added PMA2 functionality. Your feedback is much appreciated!