View Single Post
      12-20-2012, 02:29 PM   #20
UhhItsANT
Captain
United_States
77
Rep
664
Posts

Drives: 2013 BMW 335i
Join Date: Sep 2012
Location: Bay Area, CA

iTrader: (2)

Garage List
2013 BMW 335i  [0.00]
So i did this. And after i did it. Apparently it wasnt tight enough, so there was movement down there. so i went back down to redo it. as i was taking off the wire to re-secure it again, i noticed that the too wouldnt line up if i decided to put the spring back in there. does the motor turn a bit more without the spring then it does with the spring (im guessing spring holds it back from going all the way) since there a grove in inside the exhaust to prevent the flap from going further then allowed.

If i look at the motor side if i were to put the spring on that side it wouldnt go in, the top of the spring wouldnt fit due to the bracket that holds the motor.

Can someone check to see if there is like that too? Has anyone tried to put the spring back?
Appreciate 0