Quote:
Originally Posted by NitramA
Good question and as I'm still feeling my way with this I'm not sure.
Following the instructions , the last steps were:
1/ VCM. Load the edited FA file.
2/ Calculate FP.
3/ Click VCM master tab and write FA FP
4/ Read FA FP to check FA has been saved to car.
No errors were reported.
Mind you it didn't explicitly say it was successful either!
After this I just disconnect from the car.
Thanks for your help with this - it's very much appreciated.
|
Ok, that's only half the work. You still have to recode the NBT module based on the new VO.
From Shawns instructions:
Connect => Read FA (VO) => Activate FA (VO) => Read SVT (VCM) => Right-Click on HU_NBT (the ECU itself not the underlying CAFD) => Select CODE.
That will program the NBT based on the new VO.