Quote:
Originally Posted by GCoe04
Shawn, I followed the instructions and I coded out the driver side to not be active.
ACSM = > airbag_fahrer_stufe_2 = nicht_aktiv
ACSM = > adaptive_airbag_fahrer_vent = nicht_aktiv
But the light is still on? When I read the codes it’s telling me that the code for the passenger airbag and the driver airbag do not match with the equipment. Did I do something wrong? I see a lot about a tool32 that I need to reset the fault? How can I get this tool if your could guide me please.
I also show the stufe_1 as nicht_aktiv. Does this need to be active? First time coding with E-Sys. Unsure what I might of done wrong.
|
I Think you just need to clear code.
Your Receive PM function is disabled. PM me here when working, or send me a PM on Bimmerfest.