[freespirit]

Originally Posted by freespirit

LCW retrofit completed successfully along with Kafas2(LDW, SLI & HBA) and heated steering wheel.

However there are 3 faults in ISTA. One of them is "ZGM:No flexray initialization"

opened port 3 using tool32 --> ZGM_01.prg --> 0x03;0x01

status flexray pfad shows only 4 ports ... that's where the confusion is ... should I have 4 ports or 8 considering I have FEM high.

also left the car to sleep all night yesterday.

Attachment 2365805

Also if you see the below tree ... flexray lines are used by only four modules DME, SWW, EPS and ICM. If I initialize ZGM using ISTA, ZGM comes green and SWW disappears

Attachment 2365809

Do you have any advice or hint for me on how to resolve this please.

Thanks you so much in advance!

So this issue is now resolved.

I have retrofitted kafas2 along with LCW and that retrofit left some faults in kafas2 and DSC. Not sure if those faults has anything to do with ZGM initialization but as soon as i fixed them and brought kafas2 and DSC to green, I was able to successfully initialize ZGM without closing port 3