Quote:
Originally Posted by thejeremyman9
IIRC BM3 does reset adaptations (no trans, but DME-related ones) when you flash/change maps. That could be it. Will be interested to see what happens when you flash again.
|
I think it is because this happened right after my last flash. We'll see next week.
To keep things on topic, here is a response from XHP and my question about whether or not I need to turn on torque limits:
Hi Richard,
our OTS MAPS have pre-defined torque settings.
Stage 1 and 2 are 800NM for all gears and stage 3 uses 1000NM in all gears.
You only should activate the torque limits if you want to limit certain gears. Like for 1/4 mile cars with "bad tires" you can limit the 1 and 2 gear to 600NM as example to lower the wheelspin.
Best regards,
Semin Biscevic
Product Genius xHP & xDelete
RBT TUNING GMBH – Home of xHP Flashtool & xDelete