While I was doing the pump I was thinking about the EKPS. This thing gets smokin' hot at times. Seen that some were modding them for better cooling so I figured why not. These things are fairly cheap on Ebay so I wasn't too worried about messing anything up. Added a heatsink and fan after drilling some holes in the housing. Power is sourced from the fuel pump control wires. You will need to trim some of the foam from the back of the cover. Probably a good idea to add a fan guard because I can stall the fan of I push hard enough on the panel. Used a Noctura fan and it's whisper quiet but moves a good amount of air. Can just hear it when you put your ear to the seat which is good because you know you didn't block it!
|