|
Hi, I should probably update the pictures there. There is one extra wire in each for inner turn signal.
You need to run the cable all the way from REM. The picture of the tailgate wiring can give you the idea on how the wire should go.
For the outers you just need to swap few pins in the main connector as per schematic in the word document.
Coding, there are 2 ways of doing that. Either adding HO-WORT and CODE REM with that new SALAPA element. However if you have older I-Step, it might not work. Then you would have to change all of the parameters manually.
I can help you with both and recommend which way to go if you'll tell me your vehicle I-Step level. I assume that you have E-Sys available?
|