Quote:
Originally Posted by Gabrola
If you have the standard speaker system without an amp, this will be a bitch to wire. The speakers are connected directly to the headunit so you will need to remove the speaker pins from the headunit quadlock connector and somehow route these wires to the ASD module in the back. Then you need to install additional wires from the ASD module back to headunit again.
On the Hifi system this would have been much easier since all the wires you need are connected to the amp in the trunk.
|
He can also install the asd module near the head unit.
Because he has no amp there's no need to install the asd in the trunk.
@[joq3]
yes, these are the pin numbers.
And normally you should also find the cable colors like in the picture.