Quote:
Originally Posted by V_ARZADON
Doing some LED conversions on my Low/High/Fog and I wondered if you needed any load resistors?
|
I used these, no resistors or anything, but you do need to code the lights to LED and turn off warm/ cold checks. I said this above but I will say it again, I DID NOT use LEDs in stock low beam halogen housings. The glare was insane and if you do this and cause an accident you could be seriously liable. Others have done this, but again, at your own risk.
High/ low (H7):
https://amzn.to/33d7g2i
Fog (H11):
https://amzn.to/33d7g2i