Quote:
Originally Posted by Gabrielisimous
Did you try following their recovery guide?
1.Download the "px6-9.0_format.zip" system recovery file
2. Copy the zip file (PX6-9.0_reset.zip or px6-9.0_format.zip) to an empty SD card or USB flash drive.
3. Insert the USB flash drive with the recovery zip into any USB port of the monitor as shown below:↓
4. Power on the monitor by putting your car into ACC mode or start your car's engine.
5. Once you see the monitor powered on IMMEDIATELY power OFF the car and monitor then power back on the monitor again. Doing this will put the unit into upgrade mode.
6. Wait for the update process to fully complete. When the update is done you will see the message below "please remove the usb disk".
Unplug the USB flash drive to automatically restart the monitor.
7. The monitor will automatically restart after unplugging the USB flash drive. It takes 5 minutes for the system to complete its first initial boot-up. Please be patient for it to complete.
If you see the "NO SIGNAL" message appear as shown below you will need to power off the monitor wait 45 seconds and then power on the monitor again.
|
Thank you, i will try that method, recovery file means px6.zip update?