100% correct Shawn i was choosing target with direct suffix. Now I have a new issue.
When I activate the fa browse to what I want to change edit fl however the save button is grayed out on top not allowing me to save. Any advice? As always thanks in advance
Quote:
Originally Posted by shawnsheridan
I know you say you followed the instructions, but 95% of the time, this error is due to incorrect Connection Parameters.
Verify the following when connecting:
On E-Sys Toolbar Press the "Connect" Button and in the "Open Connection" window under "Target", select desired Target Vehicle based on car's Chassis.
(e.g. "TargetSelector:Project=F020-14-11-502, VehicleInfo=F020")
*NOTE: Do NOT select the Target with the "_DIRECT" suffix (e.g. TargetSelector:Project=F020-14-11-502, VehicleInfo=F020_DIRECT).
In the "Open Connection" window under "Interface" select "Connection via VIN".
In the "Open Connection" window under "vehicle-specific parameter (optional)" select "Series, I-Step Shipment", and leave the two Dropdown boxes blank.
*NOTE: Do not select "Read parameters from VCM".
|