[ceedawg]

Originally Posted by JaredG_F30

raichean solid run man. I haven't' looked at your logs yet but I would bet that the DME is pulling timing due to high IATs. Make sure that the hood is up and you have some really good fans blowing right on the FMIC. Also give it some time between pulls. When I dyno'd my second pull was actually stronger then my first pull with a 10 min gap. Ambient was about 79 and my IATs never went over 106 degrees during the pull. Here are my logs for comparison. This is on California 91 octane with 2 gals of corn thrown in.

1st run
http://www.bootmod3.net/log?id=5a4589a2d10b4307dadd6db7

2nd run
http://www.bootmod3.net/log?id=5a458b9bd10b4307dadd6db8

Are you able to post it with just the timing ,psi,rpm,iat,and boost? Very crowded logging all those things. Thanks Your IAT's are nice and low compared to Raichean session. Interesting.