Hi all, been reading this thread and I'm about to get my CP installed and I just want to make sure I put the O rings in correctly.
As mentioned the O rings from the CP to the IC is directional. which way should it be if say the top was the CP and bottom was IC.
I've been playing around with both ways and both seems to fit in nicely, although one way was a lot easier to go in than the other.
It seems like the O ring on the left of the CP in the picture is the right way if I was to put it in, but I could be wrong.
See pictures below.
Last edited by G80S58; 11-08-2019 at 10:39 AM..
|