Quote:
Originally Posted by MrChang
Hello!
I installed the lights today without having to remove any trim panels except for the battery panel, the light covers and the left outside tailgate panel as shown on your photo. I manage to route the cables by using a steel wire (with plastic isolation) to drag the cable through. One issue I got (I dont think I have seen that been mentioned) was the LCI inner tail lights had a M8 screw instead of a M10. I manage to solve it by removing the flared M10 nut and replace it with a washer and M8 nut.
Next step will be coding.
|
Mr Chang,
I’m about to give this a go but need clarification on feeding the retrofit cable up the tailgate and into the boot to the REM. Did you remove any trim panels inside the boot to route the wires?
Thanks