Quote:
Originally Posted by deneyer
Quote:
Originally Posted by freespirit
Seller also confirmed to rotate the cable by 180 degrees. Now the problem is i had to trim the hud side connector as well. Can you please help to figure out which pin is voltage and which is ground on the hud?
After 180 degree rotation
Attachment 2314818
Can you please tell if the voltage and ground wires look correct or should they be swapped.
Attachment 2314819
Thanks
|
i dont know if its both sides that need to be truned 180°, for the snap-in i only needed to turn 1 of the 2 sides 180°
|
Finally it worked
. I only had to swap the red/yellow and brown wires. Didn't rotate cable on any side. However I tried all 8 combinations.
Thank you so much for the help
__________________
Click appreciate if this post has helped you
Retrofits: NBT evo ID6, 6wb cluster, heated steering wheel, HUD, Kafas2 with LDW, SLI, HBA, FCW and pedestrian warning, LCW, Surround View, Parking Assist and ACC with Stop