View Single Post
      01-10-2018, 03:26 PM   #1
mike@x-ph.com
BimmerPost Supporting Vendor
mike@x-ph.com's Avatar
United_States
10963
Rep
120,260
Posts


Drives: 2007 e92 335i / 2013 F30 328
Join Date: Sep 2013
Location: Las Vegas

iTrader: (20)

Talking OBD Flash Tune From Active Autowerke **No ECU REMOVAL REQUIRED**



Can be done from home with the use of the Simon Cable.

You still have the option to send your ECU to Active direct if you do not wish to purchase the Simon Cable.

Active Autowerke offers unparalleled performance software. Through careful remapping of the factory BMW DME tables, various elements such as ignition timing, fuel delivery, and part throttles are reworked to create performance gains.
The Active Autowerke upgraded software is designed to operate with gasoline that has an average octane rating with full emissions to create a clean burning combustion with good AFR’s all within factory specifications.

Available Options:
  • Cold start delete
  • Stage 1 or Stage 2 maps for 91-93 octane
  • Off Road Only Downpipe Map
  • Burble Option
  • Tuner flag removal
  • OBD Flashing Option

Performance Specs:
  • Up to 80hp gains : Rear wheel HP measured on the dyno

This is an OBD flash tune, no need to remove the ECU

Attention Florida Customers: If you are local to Active Autowerke (9940 SW 168th Terrace, Miami, FL 33157), there is no need to purchase the Simon Cable. All you need to do is purchase the map from Extreme Power House and drive down to AA for a free install.



***EDIT***

Dyno from a customer.


Car mods: Catless Downpipe

Note: Car is using stock intercooler. Temps were going over 180 degrees on high RPM which caused the ECU to cut power.
A car with a quality aftermarket intercooler will make even more power on high RPM.

Flash Tune vs stock



Same customer, same day same car with Active A piggy.
Im posting this A8 dyno to showcase the power delivery difference between the Active flash and their piggy.

Active 8 Vs Stock


F30 335 Stock (With Downpipe) vs Active Autowerke OBD Flash Stage 2 +65whp / +109wtq
(notice how important a quality FMIC is to this car. it loses a lot of power after 5500 RPM)


Last edited by mike@x-ph.com; 02-23-2018 at 12:58 PM..