Quote:
Originally Posted by F06WINS
Hi everyone I use this older thread as I have an issue with injecting a CAFD into ZBE3 after coding all ECUs on my 2014 F32 car.
I refer to ZBE3 because ISTA throws me the following error on the CON:
CON 801410 CON: No current coding data stored
Fault description: The control unit was not encoded after programming
When I select "Detect CAF for SWE" the following error message appears:
View post on imgur.com
Thus I cannot restablish the CAFD.
Is this because I have the Ceramic Controller from another car? Meaning I have to mount the original controller back and then it should be fine?
That is what I suspect but as I have never touched ZBE3 I am many of you here know better if the cause is likely to be another?
Thanks for any input.
|
Yes, the issue is your Ceramic Controller. Put back original or Flash and Encode Ceramic one.