05-24-2022, 03:44 PM | #1 |
New Member
1
Rep 5
Posts |
N55 misfires (need help)
Featured on BIMMERPOST.com 140002 - Combustion misfires, several cylinders: Damaging exhaust gas after starting up. 140010 - Combustion misfires, several cylinders: detected. 140102 - Combustion misfire, cylinder 1: Damaging exhaust gas after starting up. 140110 - Combustion misfire, cylinder 1: detected. 140202 - Combustion misfire, cylinder 2: Damaging exhaust gas after starting up. 140210 - Combustion misfire, cylinder 2: detected. 140302 - Combustion misfire, cylinder 3: Damaging exhaust gas after starting up 140310 - Combustion misfire, cylinder 3: detected. 140602 - Combustion misfire, cylinder 6: Damaging exhaust gas after starting up. 140610 - Combustion misfire, cylinder 6: detected. I have a fbo 2016 bmw 435i xdrive grand coupe running MHD stage 2+. Been running it for a year now. Now won't go past 1500 rpm while driving without bogging out. Started when I past someone and white cloud of smoke came out the back. Car was sitting for 2 weeks while I was away and this happened on the 3rd day back driving it. Changed spark plugs and coils please give me your thoughts! Thanks |
05-24-2022, 06:56 PM | #3 |
New Member
1
Rep 5
Posts |
I attached photos of the plugs, I didn't run the engine before changing the plugs though if that matters. Yeah I flashed back to stock. Do you think I have to drive it for a certain amount of time before it realizes and that the new plugs are in?
|
Appreciate
0
|
05-25-2022, 02:12 PM | #6 |
Major General
4392
Rep 7,629
Posts |
So to confirm:
Issue happened --> new plugs and coils --> flashed backed to stock --> tried to drive and got the codes above? If that wasnt the order, make sure you clear all codes and you can try resetting adaptations then drive again and see if they come back. White smoke implies coolant... but HG is unlikely. Is your coolant and oil levels OK? |
Appreciate
0
|
05-25-2022, 03:48 PM | #7 |
New Member
1
Rep 5
Posts |
Issue happened --> got the codes when I got home not right away, no engine light—>cleared the codes—>new plugs and coils --> drove for a minute but still felt the same as before—> no codes came up—> flashed back to stock
Used the computer to Measured the oil said it was fine. Coolant looked fine as-well I just sent it to bmw so we will find out what it was when they look at it( also looked around the engine for any fluid or anything, found nothing out of the ordinary) |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|