[Rbrown]

Hi

I have just changed to my winter wheels.

Usually, I just reset the settings and take the car for a drive and it sorta itself out.

I have done it today. Says pressures all ok and each wheel has a “green” colour. No error messages. I usually get the psi reading for each wheel. I am not getting that anymore.

Battery on sensors is ok.

My car is coming up for 6 years old. Does anyone know of this is software change or something you have to pay for through subscriptions?

Many thanks in advance.

[danb1979]

Your readings should show the PSI for each wheel...

Might be worth disconnecting the battery for 30mins or so, let the car reset and then try resetting the TPMS again

You can have the temps coded to them too, but IIRC PSI is the normal readout you get

[SkyJawa]

Sounds like it’s dropped back to the abs based system, as that just shows ok and no temps or pressure.

It’s not saying Flat Tyre Monitor instead?

[Rbrown]

Originally Posted by SkyJawa

Sounds like it’s dropped back to the abs based system, as that just shows ok and no temps or pressure.

It’s not saying Flat Tyre Monitor instead?

It does feel like it has gone make to previous generation of monitoring.
Screen looks like this….

[SkyJawa]

Oooo that is a strange one! Can you read the car to see if theres any obvious fault codes reported?

[Rbrown]

Originally Posted by SkyJawa

Oooo that is a strange one! Can you read the car to see if theres any obvious fault codes reported?

Nothing coming up. Car is due a service next month. Will get them to look at it then.
Keep hoping it will just sort itself. 🤞🤞🤞