[jaf30]

I've recently had my '16 330e go in for a polish, and subsequently the "eDrive" badges on the C pillars were removed. Unfortunately the shop did not keep note of the exact positioning, so I'm in need of a little help!

If anyone with a 330e could make a quick sketch up with some accurate measurements I'd really appreciate it.

Thanks

[f30paul]

Mine measures 50mm in from the edge of the black plastic trim around the window, and 70mm from the base of the badge to the bottom edge of the black trim at the window base/where the hofmeister kink ends, if your eyes continue that line across… hope that helps? Can sketch if clearer…

[jaf30]

That's really helpful, thanks

I'll save you the trouble of a sketch and link this. I should have done this to start with!

View post on imgur.com

What would the measurements be for these? Thanks again - you're a star!

[f30paul]

So A I had measured from the bottom of the E, and from the bottom left corner of the ‘e’ that is 50mm to the edge of the black trim. Your red line is correct, but again I measured 70mm high to the bottom of the E, not the top. Offside measurements the same, but on mine the 50mm measurement is from the bottom right point.

[jaf30]

Super!

I understand what you're saying!

Thanks again for this. Life saver