[F36_ny]

Just installed a CTS intake on my 440 and after a couple days the car threw a check engine light. Ran a diagnostic the code was p120d for intake (from what I’ve googled). Has anyone had this with any solution? I cleared the code on a scanner and it threw the code again after a day. I checked all the hoses and clamps everything is tight with no leaks.

[5mall5nail5]

Had same/similar on my N26

[Sensational]

From what I've heard it's mainly the position of the sensor that will pretty much always cause it to throw a CEL. I haven't heard of any fix for it yet, most people just clear it whenever it pops up.

[F36_ny]

Originally Posted by Sensational

From what I've heard it's mainly the position of the sensor that will pretty much always cause it to throw a CEL. I haven't heard of any fix for it yet, most people just clear it whenever it pops up.

Problem is I need to do an inspection 😵*💫

[davidr3]

Originally Posted by F36_ny

Problem is I need to do an inspection 😵*💫

Won't pass regardless once they see it :/

[chowser51]

install your original intake back on and reset everything, go for a long drive, then get the inspection then install your cst intake back in

[5mall5nail5]

My issue was that despite the CEL, I had hesitation and stalling issues.

[F36_ny]

Originally Posted by 5mall5nail5

My issue was that despite the CEL, I had hesitation and stalling issues.

The sounds it makes is glorious 💦

[5mall5nail5]

Originally Posted by F36_ny

The sounds it makes is glorious 💦

Haha yes it does sound cool until the car stalls at a light and throws codes... went back to stock