[Racing2n]

I have a Vorsteiner front splitter but none of the hardware fits due to the thickness. How have others installed these?

[_bdiddyb_]

Drill and rivet or use your own screws.

[_tlink]

Rivets

or

Wood screws & 3M tape

[Racing2n]

Thanks! My dad said to use rubber riv nuts. They look like a great solution, too.

[jv004]

3m tape and self tapping screws works. Rivets are more of a permanent solution but a PIA to remove if you want to replace damage lip or change style.

[Racing2n]

Thanks JV. I'll post some pics when I get it installed. I painted it black. The carbon fiber didn't look good on my car.

[Min2max]

I have one to but have aftermarket msport so the fitment is pretty off I was thinking of using a dremel to shave down where it hits but I may just sell it

[exE36M3]

Don't do the screws. One bump and they come right out.
Do rivets or a nylon locknut/bolt/washer combo. A little more work to get on... but they will NOT come off.

[Troy27]

Originally Posted by percychow

Don't do the screws. One bump and they come right out.
Do rivets or a nylon locknut/bolt/washer combo. A little more work to get on... but they will NOT come off.

Rivets and 3m vhb tape. Have to drill the holes for the rivets though

[Racing2n]

I finally got it installed with a combination of compression nuts, self taping screws, and double sided tape. Thanks for all the help.

[Racing2n]

I painted it black. The carbon fiber looked like crap on my murdered out car.