01-24-2020, 01:28 PM | #1 |
New Member
0
Rep 27
Posts |
INPA/Tool32 Battery Registration
Hi all,
I have scoured tons of posts on how to register the battery using INPA. However each time I try I cannot find the correct module to run the reset. From what I've read, it should go like this: 1) connect and open INPA (no prob here, coms are up) 2) F5 to choose the chassis (F30) 3) select 'Body' and choose 'Power Module' this is the issue, I only see 4 options under the body category: Body Domain Controller BDC Front Electronic Module (FEM) Rear Electronic Module (REM) Embedded Heating and Air Automatic I'm running V5.0.6 so I think that's up to date. I have not found a single post on the F30 chassis either. I also tried Tool32 loading the F01.PRG but again don't see the corresponding options. I'm about to break down and buy the Carly app and adapter but that's ~$120 (adapter and full software version) which practically eliminates the savings doing the battery job myself. So, am I just doing something wrong or do these methods only work on the E series cars? Thanks! |
01-24-2020, 03:36 PM | #3 | |
New Member
0
Rep 27
Posts |
Quote:
https://www.bimmerpost.com/forums/sh...php?p=25725808 |
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|