10-22-2020, 03:56 PM | #1 |
Private First Class
66
Rep 159
Posts |
Esys blFlash ibaDeploy disappear
Hi all,
I am in the process on updating (some of) my cars ECUs, following the F11 guide. However at step 15, it says to select boxes “ blFlash, swDeploy, cdDeploy, and ibaDeploy”, but upon Load TAL (step 10), most of the columns below disappear and I am left with only ‘swDeploy and cdDeploy’, see below. What is happening here, or what am I doing wrong? I don’t dare to continue at this stage. |
10-23-2020, 12:11 PM | #3 |
Private First Class
66
Rep 159
Posts |
I just had another go at it. I’m quite sure I selected the correct istep “shipment” (not last or actual right?). But result is the same. Any other thoughts?
|
Appreciate
0
|
10-27-2020, 03:02 AM | #5 |
Private First Class
66
Rep 159
Posts |
Thanks for the response. So small update, I’ve tried almost every version of E-sys, 3.27, 3.28, but those two didn’t detect the istep levels, I guess too old for the latest psdzdata. Then I’ve tried .30/.31/.33/.33(64bit) all of then give me the same result as seen above. Then I decides to switch from psdzdata 4.25.40 to 3.63.3(2017), still Esys 3.30.1 gave (false) result, but now E-sys 3.27.1 gave me this:
That looks more like it. Luckily my main goal was flashing the DME due to some VO coding, in which I succeeded now. But still it would be nice to be able to update all modules to the latest psdzdata level. Where to proceed from here? |
Appreciate
0
|
10-27-2020, 02:58 PM | #7 |
Private First Class
66
Rep 159
Posts |
No that’s not the issue. Issue is when using E-sys 3.27.1 + older psdzdata I get a correct flash screen with all options (blFlash, swDeploy, cdDeploy, and ibaDeploy etc.), but when using Esys 3.30.1+ and the latest psdzdata I get only swDeploy, cdDeploy when selecting the calculated TAL. Hence I cannot update to latest psdzdata, but I don’t why. Seems like an issue with either E-sys or the latest psdzdata? Ideally I would use E-sys 3.27.1, but that doesn’t work anymore with v4.25.40. I’m still on Win7 (64bit), could that be related?
|
Appreciate
0
|
10-28-2020, 02:36 PM | #9 |
Private First Class
66
Rep 159
Posts |
Noticed something else, none of the CAFDs have a green check mark after pressing Read VCM when using 3.30.1 + latest psdzdata. When using 3.27.1 + older psdzdata they áre green.
Last edited by Jimmert; 10-28-2020 at 02:46 PM.. |
Appreciate
0
|
11-02-2020, 02:39 PM | #10 |
Private First Class
66
Rep 159
Posts |
With the help of Wibbles, we’ve discovered that the behavior of E-sys 3.30+ is normal. It only shows the options that require a change. ibaDeploy is also only for NBT. And blFlash is missing, because there is no bootloader update available.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|