03-14-2020, 10:26 AM | #1 |
Registered
0
Rep 2
Posts |
ActiveHybrid 3 issue after new belt
Hi everyone. I have a 2014 ActiveHybrid 3 I recently purchased. The other day while driving the serpentine belt snapped on me. I believe this was due to OFHG gasket leaking oil onto the belt over time. I got a new belt, cleaned up the area of all the old belt as best as I could and installed it. I don't think any of the belt got past the crankshaft pulley seal as I didn't see any leaks there. Now I noticed after the new belt install that the engine seems to have a misfire\shaking whenever the engine warms up. I will try to get a video to show what is happening. Also when it does this the auto start and stop function fails and I get a drivetrain malfunction error. Can anyone or someone tell me what could be my issue?
|
03-14-2020, 10:47 AM | #2 |
Brigadier General
1781
Rep 4,456
Posts |
I would replace the belt tensioner as well. Those do go bad. Not saying that’s your issue but it wouldn’t hurt to change it.
|
Appreciate
1
Bmwfanatic19850.00 |
Post Reply |
Bookmarks |
|
|