09-25-2022, 02:34 PM | #1 |
New Member
1
Rep 10
Posts |
Initializing Headlamps Issue
Hi, one of my headlight modules were damaged recently and I replaced it with a new one. I reset the FEM with ESYS and the headlight turned on. Thought everything was good until I realized that I got a error “Adaptive Headlight Malfunction” and “Headlamp vertical aim control Malfunction”. Halos we’re on but the adaptive feature wasn’t. I read online that Initialization is needed. So I downloaded Ista, set it up via ethernet and tried to initialize. It says initialization successful the second i click initialize but i still have the error. So I tried initializing with a AUTEL device and im getting the same problem. It initialzes successfully instantly but it doesn’t really go through any initializing steps. I am so lost and am fairly new to programming/coding and have been stumped for the past couple of days. I’ve searched loads of forums for a fix but can’t figure it out. If anyone knows the solution to this or if I’m doing something wrong please let me know. Willing to tip $ if someone is able to resolve this problem. Been a huge headache. Thank you!
|
09-25-2022, 02:36 PM | #2 |
New Member
1
Rep 10
Posts |
If anyone is wondering I am getting error codes 8041B6 (LWR Faulty) , 8041BA (AHL system Faulty) and 8041FO (Right headlight driver module (TMS): Coding error)
i don’t know if the unexpected LIN slave has anything to do with it but let me know Last edited by PowerF30; 09-25-2022 at 03:13 PM.. |
Appreciate
0
|
10-02-2022, 09:32 PM | #7 |
New Member
1
Rep 10
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|