11-24-2020, 01:37 PM | #1 |
Second Lieutenant
70
Rep 208
Posts |
Hi guys, in the middle of retrofitting coral red power memory seats to my car, reading online the seats need power/ground (obviously) and two k-can wires to signal the seat module to power up. This can be apparently done by tapping into the idrive controller canbus wires.
My question is it says pin 3 and pin 4 are the canbus wires on the idrive which I'm assuming are the 2 wires in the right as on the left of the plug says 1 and right says 4. Is that correct? Thanks |
11-24-2020, 03:38 PM | #2 |
Colonel
588
Rep 2,302
Posts |
Yes, that's correct.
The numbers at the connector are the pin numbers. So 1 means pin1 and 4 means pin4. And the KCAN2 wires have always yellow/red and yellow/brown wires. |
Appreciate
0
|
11-24-2020, 04:33 PM | #3 | |
Second Lieutenant
70
Rep 208
Posts |
Quote:
Would you know how to get the seat working? I'd assume I need a ground and live to the module then tap into the idrive kcan high and low for the signal to the seat module? Then how would I get the seat heater working? This is a question to anyone who reads any help would be greatly appreciated. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|